In a oidlib file, how can I get a value from an OID and put it into a name and another value from an associated OID for the sensor value?

Basically what I have is this:

1.3.6.1.4.1.674.10892.5.4.700.12.1.6.1.1 = "2280"
1.3.6.1.4.1.674.10892.5.4.700.12.1.6.1.2 = "2400"
1.3.6.1.4.1.674.10892.5.4.700.12.1.6.1.3 = "2400"
1.3.6.1.4.1.674.10892.5.4.700.12.1.6.1.4 = "2280"
1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.1 = "System Board Fan2"
1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.2 = "System Board Fan3"
1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.3 = "System Board Fan4"
1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.4 = "System Board Fan5"

Where 1.3.6.1.4.1.674.10892.5.4.700.12.1.6.1.n contains the values and 1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.n contains the names.

I tried using "NotApplicable|Fan Speeds|Fan Speed #[1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.1]" for the name, but all I got in place of "#[1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1.1]" was a number.

Article Comments

Hi there,

The best way to achieve this is to use the "SNMP Custom Table Sensor". In your case you have to use the OID "1.3.6.1.4.1.674.10892.5.4.700.12" as the table OID during the creation. Afterwards you can choose all displayed rows, which values should be monitored and which column should be the identifier, in your case it is:

1.3.6.1.4.1.674.10892.5.4.700.12.1.8.1 = System Board Fan2

Now you can enter into the sensor name (still during the creation):

My Static Sensor Name / [rowidentifier]

The sensor name will then look like "My Static Sensor Name / System Board Fan2".
Settings: Settings

Best regards.


Apr, 2017 - Permalink