HOW CAN I SEND THE VARIABLES DATA IN EXECUTE HTTP ACTION?

Modified on 2025-06-10 21:35:40 +0200

Hi, i need to send the notification by EXECUTE HTTP ACTION, in my server i get the request but i cant take the variables, can you show me a little example to get it?

how i have to send the data on Postdata field?

Thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Depending on the receiving device or service, the format of the postdata may vary. An example could be:

message=The device %device is %status

You can find all available placeholders on the following page.

Best regards.

Apr, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

HOW CAN I SEND THE VARIABLES DATA IN EXECUTE HTTP ACTION?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.