95th percentile for custom IPFIX sensor

Modified on 2025-06-10 21:37:04 +0200

I am trying to get a 95th percentile bandwidth usage figure for a custom sensor for a calendar month.

I can do the calculation, but I would like to display the figure on the table that currently shows "Channel ID Last Value (volume) Last Value (speed) Minimum Maximum Settings".

Is this possible?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you for the KB-Post. Please bear in mind, Percentiles are only available in Repoprts, not in other parts of the PRTG interface.
If this question is indeed about a report not displaying percentiles, we need the full report setting for further troubleshooting. Please then share the settings as a screenshot here.

best regards.

Mar, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

95th percentile for custom IPFIX sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.