Threshold Trigger

Could you post some screenshots of the notification configuration?

This is the notification configuration of the sensor.

And this is the trigger notification.

Erm, those limits are a bit high ;) What exactly do you want to measure?

The utilization of those links, some days reach more than 80 Gb, and i didn't receive the proper notetification.

You have configured a speed trigger where you need a volume trigger instead. This way, the notification only triggers if the link speed goes above 80gbit for more than 60 seconds ;)

Yep i know, the problem is that the link reach sometimes 90 Gb and didnt goes down until 2 or 3 hours, and PRTG didnt sent the notification

Is the link actually capable of those speeds? Was it in an up state in between (so it never was down more than the specified amount of seconds to trigger the notification)?

Of course that the link support that speed, is a 100 GB Link :) ... the think is that i don't like to create to much triggers , the reason here is why if the link goes up to 80 GB and ever higher the notification didn't work

Well, alright then - could you open up a support request with support@paessler.com, please attach the following things:

• Report of the sensor, covering the time of the incident
• Sensor log covering the time of the incident
• <your-prtg>/log.htm?filter_status=13, incident timespan as well

Then we can probably figure this out accordingly. Please tag it with [stephan], then I'll grab it :)