Solutions

ScheduledTask2XML 0x1 returncode state

Modified on 2025-06-10 21:40:38 +0200

I'm using ScheduledTask2XML which works fine but I want to change the error state on returncode 1 to a warning or ok state. I did change the returncode 1 in the ptf.scheduledtask.taskresult.ovl file but is did not make any difference. Does anyone know how to change the state of a returncode?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Bas,

After adjusting the lookup file, you need to load the lookups into PRTG. This can be done via the Setup | Administrative Tools | Load Lookups button. Does it work afterwards?

Best regards, Felix

Mar, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

ScheduledTask2XML 0x1 returncode state

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.