Solutions

Bit error Rate sensor

Modified on 2025-06-10 21:40:59 +0200

Hello PRTG Team,

is it possible to measure the BER (Bit Error Rate) in PRTG?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Sabine,

I assume that you want to monitor the error packets per network interface, if so then just enable the additional Error channels in the sensor settings of the "SNMP Traffic Sensor". If not, please explain what you exactly mean by "Bit Error Rate".

Best regards.

Mar, 2017 - Permalink

Hi Dariusz,

this is exact what I need. Thanks a lot for your excellent support.

Best regards,

Sabine

Mar, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Bit error Rate sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.