Placeholders in HTTP Push Data Advanced

Modified on 2025-06-10 21:41:48 +0200

Can you make placeholders working in field Identification Toen in HTTP Push Data Advanced sensor configuration? I am doing a lot of usage for this sensor type recently and having token name based on device and sensor name would speed things for me tremendously.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you very much for using PRTG and the KB-Post. I'm very much afraid placeholders are not possible in the HTTP Push Sensors settings field as of now. There are no plans to implement this for the near future to be honest, as there have been very very little requests for this.

best regards.

Feb, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Placeholders in HTTP Push Data Advanced

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.