Can we change color of sensors based on what group they belong to?

Modified on 2025-06-10 21:41:50 +0200

The idea would be that different groups have sensors belonging to different customers and I would like so that when there is an alarm (down sensor) on a special customer to have a different color than the usual customer. Is it doable ?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Unfortunately, this is not possible within PRTG and I am afraid that it will not be implemented either. We assume that the added value does not affect most of the customers due to the very low request rate of such a feature.

Best regards.

Feb, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Can we change color of sensors based on what group they belong to?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.