Default Scanning Intervals? and will change frequency once down?

Modified on 2025-06-10 21:42:09 +0200

Hello,

Firstly I would like to know ss it the default scanning intervals of each sensor is 30s? and where I can verify?

and after read this KB https://helpdesk.paessler.com/en/support/solutions/articles/760000635114643-can-i-change-scanning-interval

Some further question.

1. Does it allow to modify each sensor scanning intervals?

2. When detected sensor down. Does the scanning intervals will speed up or just keep same is default setting?

Thanks!

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you for your KB-Post. You can set the interval for most in their settings. And PRTG will keep the same interval if a sensor goes down.

best regards.

Feb, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Default Scanning Intervals? and will change frequency once down?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.