When I reuse auto discover on a device, the scan does not start

Modified on 2025-06-10 21:42:46 +0200

hi, I want to add a new sensor to an existing equipment by auto discover. on free license, when i reuse auto discover on a device, the discover does start. but now, with license, When I reuse auto discover on a device (right click), the dsicover does not start regards.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Was the device discovered by an auto discovery or created manually? If it's the latter, you need to configure the auto discovery on a device level in order to make it work. Can you check that? :)

Feb, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

When I reuse auto discover on a device, the scan does not start

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.