i have converted Sonus Switch MIB to oidlib and saved it to library folder. Then Added my Sonus switch on PRTG, please tell me how to proceed to monitor all Trunk Groups on my Switch for no of Call?

Article Comments

You would need to import the Sonus Trunk MIB, as well as all the underlying MIBs, as listed on the following page:

http://www.oidview.com/mibs/2879/md-2879-1.html


Mar, 2011 - Permalink

Yes..I have already imported Sonus Trunk Group MIB. Firstly I added a Group for my Sonus Switch than wanted to add Trunk Group on it as "Add Device" and then wanted to add Sensor.

Please help me with that...


Mar, 2011 - Permalink

Then please use the "SNMP Library Sensor" and select the imported Sonus oidlib.


Mar, 2011 - Permalink

Hi ...Thank you very much.. I have been able to add TG and respective Sensors on PRTG.


Mar, 2011 - Permalink

After using the MIB Importer tool where you able to see your imported MIB in "SNMP Library Sensor" as an option? I am not, stuck on this bit for a while now.


Feb, 2017 - Permalink

Was the import with MIB Importer successful? Can you share some screenshots showing the process/steps that you take? Also, try if restarting the PRTG Core Service does help.


Feb, 2017 - Permalink