Some time ago I changed the CPU Load Thresholds Upper warning to 25% and Upper Error to 50%. These settings were changed once and all sensors (existing and new) inherited this new setting.

I do not remember were in the interface I made this change.

I would now like to modify these values again to 55% and 60%.

I have spent many hours looking through the interface but can't find the root setting for these thresholds.

Please can you advise were to look?

Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

This was probably set using multi edit :)


Feb, 2017 - Permalink

Thanks for replying.

I don't remember using multi edit, and this would have only set the values for existing sensors.

In this case all new sensors are also getting the 25% ,50% values.

Is there a template for the sensor that could be edited?


Feb, 2017 - Permalink

Is it possible that you've used a device template to create them by any chance? On the root group perhaps?


Feb, 2017 - Permalink