I have a group called VPNs and another one called Links, I did this to better organize the devices. I created a sunburst map to monitor all these devices. Inside the VPN for example I have dozens of devices, but I don't want the entire group VPN (inner circle on sunburst graph) to go red when only one VPN is down. If possible I would like that if 3 or more VPNs are down than the group VPN should go red, if that is not possible to configure then I would like the group VPN to never go red at all. How can I do that? Thanks

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Vinicius

The sunburst itself cannot be changed. It always inherits the worst status to the next layer.

But you can setup a Business Process Sensor to go into alarm state if a certain percentage of input sensors are down.


Feb, 2017 - Permalink