The current setup at my location is a single Core server with no probes in use. We are adding additional probes to handle the load according to recommendations. I am looking to find a way to take current sensors that are reporting to the core server and have them report to the new probe server. Can someone tell me if I am going about this in the correct way or is this not how it works?
move sensors from core to probe server
Modified on 2025-06-10 21:43:53 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hi there,
You can move entire groups of servers to different remote probes. Just make sure that you don't use probe dependent sensors, such as "SNMP Trap", Syslog Receiver" or QoS. To move a group or server click with the right mouse button on a group or server and choose "Move... > To other group". Now you can choose the new location of the group or server.
Best regards.
Feb, 2017 - Permalink