What is "80041006: There was not enough memory for the operation."?

Modified on 2025-06-10 21:44:59 +0200

I have set up a PRTG sensor to monitor the status of SQL service on remote server. I have received "warning" and "down" alerts with the detail: 80041006: There was not enough memory for the operation. This is followed by an "up" alert.

Does that mean I have a memory problem on PRTG or the remote system? What is the fix?

Thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Scott,

this is an issue on the target host. But unfortunately the message does not necessarily refer to 'free available memory' (RAM), it might be the special reserved OS-memory. I'm afraid there is very little we can do from PRTG with this 'error'.

best regards.

May, 2011 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

What is "80041006: There was not enough memory for the operation."?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.