MSMQ Monitoring on a MSMQ Cluster
Modified on 2025-06-10 21:46:20 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
We have Windows MSMQ setup on a failover cluster.
I am struggling to find a way to add a sensor to monitor these queues, as they are not visible on the standard MSMQ sensors.
Any suggestions?
Thanks guys.
Article Comments
It's the Private queues I am trying to monitor.
Jan, 2017 - Permalink
Hi Jesse,
Are you able to see the private queues when connecting remotely from the PRTG host (or Remote Probe if applicable) using management console?
See also:
Also note that this sensor cannot monitor sub-queues.
Kind regards,
Erhard
Jan, 2017 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
It's the Private queues I am trying to monitor.
Jan, 2017 - Permalink