how to add sensor for my dhcp address 192.168.53.0 in a port?

Modified on 2025-06-10 21:47:02 +0200

i want to add a sensor for a new user being assigned to a port identified by the dhcp address 192.168.53.0. so that i can have a graph of bandwidth usage of internet by that user.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

The only way I can think of would be flowbased monitoring with appropriate filters that extract that traffic you're interested in.

Or install a Remote Probe directly on the host of interest and put a Packet Sniffer on it.

Kind regards,

Erhard

Jan, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

how to add sensor for my dhcp address 192.168.53.0 in a port?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.