Hi Team,
Hopefully this is a simple question that I'm missing an obvious answer to.
I'm adding a couple of new remote probes into my core installation.
The problem I've faced is the access keys from the primary server doesn't sync over to the failover servers automatically.
Is there anyway to force a sync of these keys, or do I need to break the cluster each time to add the keys and then re-join the servers again.
Cheers.
Article Comments
Hi Nick,
The settings of the "Setup > System Administration > Core & Probes" page are already automatically synchronized to the failover server. I just checked the configuration file of one cluster node and the keys are set properly. The issue here is, that the read only interface does not display multiple line, only the first line is displayed.
I will forward the findings to our developers, but good news, you will not need to break the cluster for every new remote probe.
Best regards, Felix
Jan, 2017 - Permalink
Hi Nick,
The settings of the "Setup > System Administration > Core & Probes" page are already automatically synchronized to the failover server. I just checked the configuration file of one cluster node and the keys are set properly. The issue here is, that the read only interface does not display multiple line, only the first line is displayed.
I will forward the findings to our developers, but good news, you will not need to break the cluster for every new remote probe.
Best regards, Felix
Jan, 2017 - Permalink