NetApp cDOT System Health SOAP sensor does not see both nodes

Modified on 2025-06-10 21:47:45 +0200

NetApp cDOT System Health SOAP sensor is not seeing both the nodes in the cluster. It is only listing the cluster's UUID identity as a node instead of the 2 individual nodes.

Our NetApp cluster is running cDot version Ontap 9.0. Is 9.0 not supported yet?

Regards, Lia

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Lia,

Thank you very much for your knowledge base post.

You've got mail! It's highly probable that I provide you some files, which are better transmitted by email.

Best,
Sebastian

Jan, 2017 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

NetApp cDOT System Health SOAP sensor does not see both nodes

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.