Solutions

Speed

Modified on 2025-06-10 21:51:33 +0200

I monitor or Ping my ubiquiti access point through PRTG. It was very help ful, because i`m able to ping my all AP through single interface.

But is there any sensor for measuring the speed, like how much bandwidth this IP or Ap consumption. so i know which ap is in maximum load mode.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

Perhaps the APs offer monitoring via SNMP? If so, please enable and configure it properly and add the configured details to the group/device settings within PRTG. Afterwards add the "SNMP Traffic" sensor and check if you get any result. This way you can monitor the network interfaces of the Access Points directly and see their current utilization.

Dec, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Speed

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.