sflow monitor multiple interface on same procurve switch

Modified on 2025-06-10 21:51:59 +0200

Hi, I On our Procurve switch we have sflow been enabled for mutiple ports, lets say port/interface 1 & 2. How can I monitor the multiple interface in PRTG ? When I add a sensor and select sFlow/sFlow (Custom), I dont see an option to choose an interface.

Any help would be much appreciated, thank you.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

You can do this with two Sflow-Sensors listening to the same stream of sflow-packets, but then using the Interface[] -Filter. Please be aware, that the filter only works with numerical values. We cannot say which value represents which interface, this depends on the device and its configuration.

Dec, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

sflow monitor multiple interface on same procurve switch

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.