Solutions

Create snmp sensor

Modified on 2025-06-10 21:52:49 +0200

I try to monitor the state of a Fortinet firewall link The OID seems to be iso.3.6.1.2.1.2.2.1.2.3 = STRING: "wan1" but I don't know how to configure it.

Any help will be appreciated.

Rgds

David

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

You can create this by using the "SNMP Custom String" Sensor. Use the following OID to create the sensor: "1.3.6.1.2.1.2.2.1.2.3".

Please not that this will only monitor the description of a certain interface.

Dec, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Create snmp sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.