I am confused about how ipfix is implemented in PRTG. I setup my initial ipfix sensor on my DMZ router monitoring just one port to upstream ISP. I now have another switch port i need to monitor for ipfix. When I add the sensor and collect information all that I see is data and IPs from the first sensor. I get no data specific to that port. I have paused the orginal sensor and continue to get ipfix info from first device. I must have something wrong. Any ideas? Thanks Both ipfix export devices are extreme switches.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear davekordyban,

Thank you for your support inquiry.

Please contact us directly and provide us a support bundle for further analysis. We will need a couple of further information, therefore the communication via Email instead of the knowledge base will be easier.

Best,
Sebastian Kniege


Dec, 2016 - Permalink