Solutions

WMI Service Working Memory Set

Modified on 2025-06-10 21:53:35 +0200

Good Day,

I have a service that is monitoring the Working Set however I would like it to put the sensor into a red state if the working set memory creeps above a certain point.

Any help would be appreciated.

Thanks

Daniel

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear Daniel

The easiest way would be to open the according channel (memory) and enable the limit evaluation. Then please set the upper error limit accordingly.

Nov, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

WMI Service Working Memory Set

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.