How do I add Gigamon Devices in PRTG to monitor traffic flow.

Modified on 2025-06-10 21:54:06 +0200

I already adding gigamon device using local probe and choose netflow v9 sensor. It is the channel automatically appear when I adding netflow v9 sensor?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Dear rajaserai1,

Thank you for your knowledge base post.

Have you already checked our manual regarding monitoring purposes using our Flow sensors? Did you proceed an auto-discovery on that device and had it created NetFlow v9 sensors automatically?
Please contact us directly and attach a support bundle to allow us to further analyze your issue.

Best,
Sebastian Kniege [Paessler Support]

Nov, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How do I add Gigamon Devices in PRTG to monitor traffic flow.

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.