Hi,

I've recently installed PRTG Network Monitor and setup several Enterprise SNMP Sensors which uses SNMP GET and they work as expected. Also setup the SNMP Trap Receiver sensor and the traps are shown by PRTG Network Monitor.

Can you confirm if PRTG can decode the bindings section based on the Enterprise MIB and display meaning information of the varbinds and values?

Thanks & Regards, Anandha Krishnan

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Anandha Krishnan,

You can copy the manufacturer's MIB file into the directory

C:\Program Files (x86)\PRTG Network Monitor\MIB

This folder will also contain the mibparser.log file. This will allow you to check if the file could be successfully imported by PRTG. It will also show the erroneous lines. If the information of the traps is included, PRTG will translate the traps accordingly.

Best regards, Felix


Nov, 2016 - Permalink

Hi Felix,

Thanks for your valuable inputs. I followed your instructions and can confirm that PRTG translates the traps accordingly.

Regards, Anandha Krishnan


Nov, 2016 - Permalink