change disk space warning for all sensors

Modified on 2025-06-10 21:57:08 +0200

Hi, is there a simple way to change the warning level for all sensors from 20% to 15%?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there,

This can be done by navigating to "Sensors > By Tag > W > WMI Free Disk Space (Multi Disk)". Afterwards you have to mark all sensors and go into the sensor settings by clicking on the little wrench symbol, then you can change the limits under "Set limits checked against all disks".

Nov, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

change disk space warning for all sensors

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.