Sms text works when testing but not in trigger

Modified on 2025-06-10 22:02:56 +0200

I have sms text notifications setup. When I test the notification it works. When I put the entry in a trigger it does not work. In the log for the sensor it states: "Threshold Trigger sending SMS (Sensor/Source/ID: 7349/7349/2)"

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Bill,

When you tested the notification, you did so on PRTG's notification overview page or by manually using the URL in a browser? The sensor message states that the notification got triggered correctly. If something went wrong after that, please take a look Logs | System Events | Notitications to see if there are further details about possible errors.

Kind regards,

Erhard

Sep, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Sms text works when testing but not in trigger

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.