Solutions

sflow sensor shows no data

Modified on 2025-06-10 22:03:27 +0200

On the switch I configured 1 collector to PRTG server, 1 collector to sflow tester, tests shows receiving packets OK, PRTG server shows "This sensor has not received data for X minutes Y second."

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello xi,
thank you for your KB-Post.

Please share a screenshot from the sFlow Tester, this allow us to review the results from the tester.

Best Regards,
Luciano Lingnau [Paessler Support]

Sep, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

sflow sensor shows no data

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.