Netflow Sensor not picking up new IP address
Modified on 2025-06-10 22:06:13 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi All,
I've added a new IP address to my PRTG server but when adding netflow sensor it shows the IP addresses of the other NICs but not the new one I added. Is there any way to add this new IP please?
thanks,
Jay
Article Comments
Dear smeego
Did you restart the PRTG services after you added the IPs? Are those IPs bound to physical NICs?
Sep, 2016 - Permalink
Thanks Arne,
I've restarted PRTG services and I can now see my new IP. Thanks so much.
Jay
Sep, 2016 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Dear smeego
Did you restart the PRTG services after you added the IPs? Are those IPs bound to physical NICs?
Sep, 2016 - Permalink