Solutions

SNMP value representation inquiry

Modified on 2025-06-10 22:06:20 +0200

I control the SNMP device showing the voltage of 230V. The device exposes the information that the window displays depending on the number 0 or 1. 1 indicates the correct status, 0 means there is no energy. How to make - when shows 1 this to be green when it displays 0 was red?

Artur

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello there, thank you for your KB-post.

Please review the following KB-post which explains how to implement lookups:

Value interpretation (aka Lookups)

If you wish to use range-based lookups, please check this example:

Range-based lookup

Best Regards,
Luciano Lingnau [Paessler Support]

Sep, 2016 - Permalink

I used the first description. It works very well! Thank you for your help!

Artur

Sep, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP value representation inquiry

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.