I am setting up a cluster with PRTG 8 and I have followed the steps in 10 Steps to Set Up a Cluster—Scenario 3: You've Set Up Two PRTG 8 Installations Already. However, upon trying to access the web interface on the fail over node I receive and error. System emergency. the system was halted, because of the following: The license of this cluster member is not valid for operating in the configured cluster. Now my company has the 100 sensor license. The master node states that the fail over node needs to be activated. I am not sure exactly what is going wrong or where. Best regards - john
Cluster/License issue
Modified on 2025-06-10 22:07:08 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hallo,
please send the Logs(System) folder from both the master and failover note to
support @paessler, com
Jan, 2011 - Permalink