When I try to add an SNMP Cisco sensor to PRTG to monitor UCS or Cisco Integrated Management Controller it fails and throws back an error 2003. Can you list the most common errors with Cisco UCS sensors and provide possible reasons and solutions?
Would it be best to monitor Cisco device through primary network port or CIMC port?
Article Comments
Dear tyrosales
Error -2003 usually means that no SNMP connection could be created using the address, port and string setting provided. Please try to connect with SNMP outside of PRTG using our SNMP Tester. Please enter the according address and connection settings and try to read the device uptime.
Are you getting a result, or a -2003 error as well?
Aug, 2016 - Permalink
Dear tyrosales
Error -2003 usually means that no SNMP connection could be created using the address, port and string setting provided. Please try to connect with SNMP outside of PRTG using our SNMP Tester. Please enter the according address and connection settings and try to read the device uptime.
Are you getting a result, or a -2003 error as well?
Aug, 2016 - Permalink