SMNP Traps Sensor goes Back to up
Modified on 2025-06-10 22:09:10 +0200
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Important: We no longer maintain this article. The information might be out of date.
Hi there
I have installed SNMP Trap. Everything works fine. My Network devices sends a snmp trap every minute. So in PRTG i will check the Sensor every minute. So as soon as the first traps arrive the sensors changes to red. That's ok and how it should be. But within 2 or 3 minutes the sensor turns green again even if my network devices is continuing sending snmp traps. Did i miss on setting?
Article Comments
Hello,
Could you please forward us some screenshots showing the "Overview", "Log", "Settings"and "notifications" tab of the sensor in case to support@paessler.com?
Please refer to this kb post.
Aug, 2016 - Permalink
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello,
Could you please forward us some screenshots showing the "Overview", "Log", "Settings"and "notifications" tab of the sensor in case to support@paessler.com? Please refer to this kb post.
Aug, 2016 - Permalink