Solutions

SNMP-TRAP-Receiver

Modified on 2025-06-10 22:09:54 +0200

I search a SNMP-Trap-Receiver for SNMPv3. Is this possible to found in PRTG Sensor Library? The actual Trap - Receiver is just for SNMP v1/v2. How can i install a Trap - Receiver for v3?

thx

wkr Frank Haase

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi,

I'm afraid that SNMP v3 traps are not supported in the current version of PRTG, sorry.

Best regards, Felix

Aug, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

SNMP-TRAP-Receiver

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.