Solutions

Interface showing wrong speed

Modified on 2025-06-10 22:09:59 +0200

Added new sensor and the interface I want to monitor is showing wrong speed. It is showing 1GB instead of 10. Is there a way for me to change that??

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Where is this wrong speed shown? In the settings of an SNMP Traffic sensor? Or in the listed interfaces while adding the sensor? Please let me know what you are referring to.

Kind regards.

Aug, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Interface showing wrong speed

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.