We are looking to add the OID to the views on our n4000 dell switches to monitor the traffic. We added the prtg monitor but get a No such instance (SNMP error # 223). Does anyone know the OID so we can enable it on the switches?
Article Comments
Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.
Hello ledgar,
thank you for your KB-post.
The SNMP Traffic Sensor within PRTG uses data from the following OID's (and sub-OID's):
| Name | OID | MIB |
|---|
| ifTable | 1.3.6.1.2.1.2.2 | SNMP MIB-2 Interfaces |
|---|
| ifXTable | 1.3.6.1.2.1.31.1.1 | ifMib |
|---|
| sysUpTime | 1.3.6.1.2.1.1.3.0 | SNMP MIB-2 System |
|---|
If you're encountering the following error message:
| No such instance (SNMP error # 223) |
Consider deploying the sensor with it's default configuration first, then enable the Additional Channels individually and saving each time, this will allow you to figure which OID/Channel is not supported by your device. The default setting of the sensor is supported by the majority of devices that support SNMP.
Best Regards,
Luciano Lingnau [Paessler Support]
Aug, 2016 - Permalink
Hello ledgar,
thank you for your KB-post.
The SNMP Traffic Sensor within PRTG uses data from the following OID's (and sub-OID's):
If you're encountering the following error message:
Consider deploying the sensor with it's default configuration first, then enable the Additional Channels individually and saving each time, this will allow you to figure which OID/Channel is not supported by your device. The default setting of the sensor is supported by the majority of devices that support SNMP.
Best Regards,
Luciano Lingnau [Paessler Support]
Aug, 2016 - Permalink