Solutions

WMI Exchange Transport Queue sensor

Modified on 2025-06-10 22:16:16 +0200

I am trying to tweak a sensor: Sensor Aggregate Delivery Queue Length (All Queues) _total (WMI Exchange Transport Queue) with effective levels and was wondering if anybody can recommend a proper upper limit. I think out of the box it triggers with error limit of 50 and warning limit of 25 which both seem quite low. Any advice?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi Shawn,

"Sensor Aggregate Delivery Queue Length (All Queues) _total" does not come with pre-configured limits, because it strongly depends on individual circumstances what should be configured there. From our end there are no guide-lines about which limits to apply for this channel, maybe other users can contribute here something.

Kind regards.

Jul, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

WMI Exchange Transport Queue sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.