Hi there

I Monitor a HP MSA 2040 with a SSH SAN Physical Sensor. Every now and then I got an error saying Timeout waiting for Response of the SAN. Restart the Controller may help.

The Default values are used for this sensor, I tried to increase the time during checks but it wont help.

Does anyone know what causes this behavior

Paul

Article Comments

Are you running the latest version of PRTG? What interval aer you using in the sensors as of right now?

Note I took the freedom to update your KB mail address since the automated reply messages kept opening up tickets in our system :)


Jun, 2016 - Permalink

PRTG Network Monitor 16.1.21.1422 The interval is now 5min


Jun, 2016 - Permalink

Could you try to update to the latest version available and see if it works then? Note that you may need to enable compatability mode in the SSH settings of the device.


Jun, 2016 - Permalink

I updated to the newest Version 16.2.24.4666. What do you mean with compatibility mode, I ve never heard about that?

Cheers Paul


Jun, 2016 - Permalink

The timeout is a new setting that came with the new SSH framework. It's configureable in the settings of the device; the last option in the SSH credentials section. You may also need to increase the timeout settings within the sensors to 120 seconds to see if that works out.


Jun, 2016 - Permalink