Hi,
I'm just wondering if this is supported? Can the server talk to a probe with a NAT address? I'm finding that I can't add a probe this way
Thanks!
Adding a PRTG probe via NAT
Modified on 2025-06-10 22:18:23 +0200
Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.
Hello Silver565,
thank you for your post.
Please review the following:
Any and all remote probes must be able to reach your core server on port 23560, so if the probes are outside your network, configure the NAT on your public IP port 23560 to the Core server's Internal IP on port 23560.
Please be aware that the Core Server does NOT accept probe connections by default, this has to be explicitly enabled/configured under Setup > Core & Probes or using the PRTG Administration Tool.
For further details:
Best Regards,
Luciano Lingnau [Paessler Support]
Jun, 2016 - Permalink