I can not use the sensors to esx install DepNet.com for several of netframework 4 as previously said to use but could not implement them yet because I keep asking for the installation of net framework when I have it installed on your computer. Anyone know what the vercion or I have to install to use them, I thank you the answer

Article Comments

Hello,

thank you very much for your KB-Post. Which exact errors do you then get? Could you please upload some screenshots showing the exact error messages?

best regards.


Feb, 2014 - Permalink

This is an image of the error that is presented to me. Now install the version of net framework 4. But when I can not implement it. There are some special version for use.

http://subefotos.com/ver/?bb639eef4837748c27d65c25b9cab2d0o.jpg

Thanks for the reply


Mar, 2014 - Permalink

Yes, you need to install .Net 4 on the same PC/Server where your PRTG is installed, not on the ESX(i)-Target.


Mar, 2014 - Permalink

That's the problem since it was installed. net 4, where the server is installed PRTG. The problem is that for some reason does not validate the vercion or not recognized as installed. Any thoughts on the case?


Mar, 2014 - Permalink

Please install it again then, sometimes an installed .Net is not properly registered, and re-installing is then necessary.


Mar, 2014 - Permalink

Already reinstalled, also down other .Net for and reinstall but the same. Could you pass me a link or the version you should install. thanks


Mar, 2014 - Permalink

I have the same problem here I have installed .net framework 4 on my PRTG server and yet nothing has changed.I also reinstalled it just to make sure but I get the same results.what should I do.


May, 2014 - Permalink

Is a Remote Probe involved? If you want to add the sensors under a Remote Probe, the host of the Remote Probe needs .Net 4 then.


May, 2014 - Permalink

Has there been a solution to this issue? We are experiencing the same problem it seems with an Active Directory Replication Error sensor.

After installing .NET 4.0 on the probe device (also on the domain controller although not necessary.) it still gives the error there we need to install .NET 4.0 on the probe before we can add the sensor.

How and when does PRTG check what version is installed? Do we need to reboot the probe first? We rather not reboot the probe as it has a lot of dependencies.


May, 2015 - Permalink

Hi Wim,

Please make sure that you have installed the .NET Framework 4.0 Full version and not the Client Profile version.


May, 2015 - Permalink

Hi everyone,

Please restart the PRTG probe service on the remote device after .NET 4 installation. It will detect the installation and sensors will become available.


Jun, 2016 - Permalink