Solutions

Active Directory Replication Sensor

Modified on 2025-06-10 22:21:22 +0200

Hi,

I am trying to add the sensor Active Directory Replication. I keep getting Access is denied unless I add the domain account as Domain Admin.

Is there a way to add this sensor with a user that does not have Domain Admin permissions?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Thank you very much for your KB-Post. To our knowledge this sensor needs domain admin permissions. You can only check with Microsoft if other specific permissions may be possible here.

best regards.

May, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Active Directory Replication Sensor

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.