Solutions

CPU load sensor with WMI

Modified on 2025-06-10 22:24:00 +0200

I setup a CPU load sensor for a server using 48 cores CPU. For SNMP, it can show all 48 cores in form of "Channel". For WMI, it can only show 32 cores.

How can I make WMI CPU sensors show all 48 cores normally? Thanks.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

You'll have to use the SNMP sensor for this one, we're limited by our 32 Bit Probe service here :)

May, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

CPU load sensor with WMI

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.