How can programmatically access probe request and probe response on the access point?

Modified on 2025-06-10 22:24:58 +0200

Hello all, I have a building I want to periodically broadcast probe request from each AP and then read all the probe response. The manufacturing of the access points are Cisco and LinkSys.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello,

Please check if the vendor of your device offers any MIB files that can be used for this purpose.

If so, you can import a MIB with our MIB-Importer.

Then you can monitor the target with the SNMP Library Sensor.

Best regards

May, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

How can programmatically access probe request and probe response on the access point?

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.