Huawei NE40E Sub-Interface (dot1q) Traffic

Modified on 2025-06-10 22:26:49 +0200

Hi Guys,

Is there any way to monitor sub-interface (dot1q) traffic for Huawei NE40E router in PRTG?

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Khairi,
thank you for your post.

Monitoring VLAN's can be rather tricky, not all devices from all vendors implement separate SNMP Counters for sub-interfaces, in some cases they're implemented but the counters are never incremented. Please review the following links, they all refer to similar scenarios (Logical Interfaces):

Best Regards,

Apr, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Huawei NE40E Sub-Interface (dot1q) Traffic

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.