Solutions

Notification of Group Failure

Modified on 2025-06-10 22:29:36 +0200

Is it possible to get a notification only if a group of sensors, or all the sensors on a device fail?

We have some failover systems that normally have one of their possible targets down, but I want to get an alert when all of a systems targets are down because that would mean that it can no longer serve users.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hi there,

This will be possible with the new Business Process Sensor. You can add the checks in the settings of the sensors and define the overall percentage of sensors which need to be in a down state so that the complete sensors turns red. This is also described in this article.

Best regards, Felix

Mar, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Notification of Group Failure

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.