Solutions

wont take my subnet for autodiscovery

Modified on 2025-06-10 22:31:46 +0200

this is the error message: "Please enter a valid class C network IP base (e.g. 192.168.0 )" I have subnetted 10.200.0.0 and have remote sites in those subnets. the tool wont let me create an autodiscovery group that references 10.200.0.0/24 my first site is 10.200.0.0/29 . . next is 10.200.0.8/29 . . etc

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

When using Class C Base with start/end (IPv4) as IP Selection method you need to leave the last digit out (10.200.0) and define below IPv4 Range Start and IPv4 Range End. Or you could use IP and subet (IPv4) as IP Selection method which enables you to enter something like 10.200.0.0/24.

Kind regards.

Mar, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

wont take my subnet for autodiscovery

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.