Solutions

HP V1920-48G

Modified on 2025-06-10 22:33:54 +0200

Dear Sirs,

how can monitor health situation for this V1920 switch only?

are there some probes/sensor for this kind of switch?

i looking for mib in the vendor site but there is a millions of it ... do you have any example to configure it?

thank you very much

luca

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello Luca,

Unfortunately, we do not have any built-in sensors in PRTG to monitor the health of the HP switch , sorry. You have to ask the vendor which mib is needed to monitor the health status.

Feb, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

HP V1920-48G

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.