Solutions

Monitoring DHCP SUPERscopes

Modified on 2025-06-10 22:35:53 +0200

Any word on monitoring SUPERscopes? I've added all scopes as described elsewhere in the KB, but we have quite a bit of them so using sensor factory to sum up scopes as someone else suggested isn't terribly practical. Especially given that scopes move around from time to time between superscopes, whereas the superscopes do not...

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

I believe you are referring to this? Sorry, there are currently no plans on addressing this.

Kind regards.

Feb, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Monitoring DHCP SUPERscopes

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.