Solutions

Local Network Devices

Modified on 2025-06-10 22:35:59 +0200

Hi there, I have a probe installed on local computer in a network. Can i monitor it's connection to different devices on the network (devices on which i can't install a probe? Please advise on how to achieave it.

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Hello.

If the system is a PRTG Remote Probe you should be able to set-up Packet Sniffer Sensors to monitor it's communication to other network devices and the internet.

Best Regards,

Feb, 2016 - Permalink

Disclaimer:
The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.

Local Network Devices

Article CommentsAttention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.

Search

Attention

Related Articles

Article Comments

Attention: This article is a record of a conversation with the Paessler support team. The information in this conversation is not updated to preserve the historical record. As a result, some of the information or recommendations in this conversation might be out of date.